Precaution
1. GENERAL PRECAUTION
When using the battery during inspection, do not
bring the positive and negative tester probes too
close to each other as a short circuit may occur.
PARTS LOCATION
SYSTEM DIAGRAM
1. SIGNAL COMMUNICATION TABLE
Driver Side Power Seat (w ...
Removal
1. BOLT, SCREW AND NUT TABLE
The bolts, the screws and the nuts, which are
necessary for installation and removal of the
instrument panel are shown in the illustration below
with alphabets.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE STEERING WHEEL COVER LOWER NO.2
4. ...
Rear washer motor
ON-VEHICLE INSPECTION
1. INSPECT REAR WASHER MOTOR
Pour the water into the washer jar with the rear
washer motor assembly installed to the washer jar
assembly.
Connect the battery (+) to the terminal 1 of the rear
washer motor assembly, the battery (-) to the
terminal ...