Toyota Sienna 2010-2024 Owners Manual: Unlocking and locking the doors from the inside
Door lock switch
- Locks all the doors
- Unlocks all the doors
Inside lock button
- Locks the door
- Unlocks the door
The front doors can be opened by pulling the inside handle even if the lock buttons are in the lock position.
Unlocking and locking the doors from the outside
Entry function (vehicles with a smart key system)
Carry the electronic key to enable this function.
Grip the driver’s door handle
to unlock the door. Grip the
passenger’s door handle ...
Locking the front doors from the outside without a key
Move the inside lock button to the lock position.
Close the door.
Vehicles without a smart key system
The doors cannot be locked if either of the front doors is open and the
key is in t ...
Other materials:
Mirror Switch Circuit
DESCRIPTION
A switch signal of the outer mirror switch is transmitted to the
selected outer mirror control ECU by way
of the body ECU. Then, the outer mirror control ECU activates the mirror
motor to move the mirror UP,
DOWN, RIGHT and LEFT in response to the inputs.
HINT:
Th ...
On-vehicle inspection
1. INSPECT BRAKE PEDAL HEIGHT
(a) Check the brake pedal height.
Pedal height from dash panel:
150.3 to 160.3 mm (5.917 to 6.311 in.)
NOTICE:
Do not adjust the pedal height. Doing so by
changing the push rod length will structurally
change the pedal ratio.
2. CHECK AND ADJUST STOP LIGHT S ...
Installation
1. INSTALL TRANSFER CASE OIL SEAL
(a) Using SST, install anew transfer case oil seal to the
transfer case at the position shown in the
illustration.
SST 09387-00010, 09950-70010 (09951-07150)
NOTICE:
Do not install it obliquely.
(b) Apply small amount of MP grease to the oil seal lip.
2. ...
