Toyota Sienna Service Manual: Power mirror control system (w/ Memory)
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
- On-vehicle inspection
Mirror
...
Parts location
SYSTEM DIAGRAM
...
Other materials:
Repair
1. INTRODUCTION
(a) This section introduces ways to determine whether
the run-flat tire is repairable or not. Repair must be
performed by following the appropriate procedures.
If a flat tire occurs, it is possible to drive a maximum
of 160 km (100 miles) at a speed below 90 km/h (55
mph) due ...
Removal
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
Remove the screw.
Using a heat light, heat the rear door window frame
moulding between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the rear door window frame
moulding excessively.
Slide the rear door window frame moulding upward
to r ...
Fuel Pump Primary Circuit
DESCRIPTION
This DTC is designed to detect a malfunction in the fuel pump (FUEL
PUMP) relay circuit. When the
system is normal, the battery voltage is applied to FPR terminal of the ECM
while the FUEL PUMP
relay is turned OFF. If the battery voltage is not applied to the FPR
ter ...