Toyota Sienna 2010-2024 Owners Manual: Deleting the contact data
For PBAP compatible Bluetooth® phones, this function is available when “Automatic Transfer” is set to off.
- Select “Delete Contacts”.
- Select the desired contact and select “Delete”.
- Select “Yes” when the confirmation screen appears.
Deleting the contact in a different way (From the “Contact Details” screen)
- Display the phone screen.
- Select the “Contacts”, “Call history” tab or the “Favorites” tab and select the desired contact.
- Select “Edit Contact”.
- Select “Yes” when the confirmation screen appears.
Editing the contact data
For PBAP compatible Bluetooth® phones, this function is available when
“Automatic Transfer” is set to off.
Select “Edit Contact”.
Select the desired contact.
Select corresponding ...
Favorites list setting
Up to 15 contacts (maximum of 4 numbers per contact) can be registered
in the favorites list.
Registering the contacts in the favorites list
Select “Add Favorite”.
Select the desired conta ...
Other materials:
Manual Up / Down Function does not Operate on Rear LH Only
DESCRIPTION
If the manual UP/DOWN function does not operate, the power window motor, the
regulator switch or the
wire harness may be malfunctioning.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK WIRE HARNESS (POWER SOURCE)
Disconnect the P38 regulator switch connector.
Turn ...
Cranking Holding Function Circuit
DESCRIPTION
The system detects the ignition switch's starting signal (STSW) and then
supplies current to the starter
until the ECM judges that the engine has started successfully. The purpose is to
reduce the holding time
of the ignition key.
WIRING DIAGRAM
Refer to DTC P0617 (See page ...
On-vehicle inspection
NOTICE:
In this section, the terms "cold" and "hot" refer to the
temperature of the coils. "Cold" means approximately -
10°C (14°F) to 50°C (122°F). "Hot" means approximately
50°C (122°F) to 100°C (212°F).
1. INSPECT IGNITION C ...
