Toyota Sienna Service Manual: Throttle body

Installation

1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2 Exhaust Side)  Apply a light coat of engine oil to the new O-ring and install it to the camshaft timing oil control v ...

Components

...

Other materials:

Repair
1. INTRODUCTION (a) This section introduces ways to determine whether the run-flat tire is repairable or not. Repair must be performed by following the appropriate procedures. If a flat tire occurs, it is possible to drive a maximum of 160 km (100 miles) at a speed below 90 km/h (55 mph) due ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINALV Caution: wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 2. Remove air fuel ratio sensor (for bank 2 sensor 1) (a) ...

On-vehicle inspection
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)  Perform a diagnostic system check.  Even if the airbag was not deployed, check if there is any dama ...