Toyota Sienna Service Manual: Steering Column

Steering System

Other materials:

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
(a) Preconditions The monitor will not run unless: The MIL is OFF. (b) Drive Pattern (1) Connect an intelligent tester to the DLC3. (2) Turn the ignition switch to the ON position. (3) Clear the DTCs. (4) Start the engine. (5) Allow the engine to idle for 10 minutes or more. ...

Shift Solenoid "D" Control Circuit
DESCRIPTION Shifting from 1st to 5th is performed in combination with "ON" and "OFF" operation of the shift solenoid valves SL1, SL2, SL3, S4 and SR which are controlled by the ECM. If an open or short circuit occurs in either of the shift solenoid valves, the ECM cont ...

CD cannot be Inserted / Played or CD is Ejected Right After Insertion
INSPECTION PROCEDURE 1 CHECK IF A PROPER CD IS INSERTED Make sure that the CD is an audio CD or a CD with an MP3 or WMA file, and that it is not deformed, flawed, stained, burred, or otherwise defective. OK: Normal CD. HINT:  Translucent or uniquely-shaped CDs cannot be play ...